Troubleshooting And Solutions - Heatmor Response 200 SSRII Operations, Maintenance Manual And Safety Instructions

trOuBLeshOOtinG anD sOLutiOns

Main Principles to Remember
♦ Enough Wood.
♦ Enough Water.
♦ Fans On – Air Must Get In.
♦ Fans Off – Air Must Stay Out.
♦ Water Temperature between 145 and 185 degrees Fahrenheit.
PROCEDURES ARE REFERENCED TO HEATMOR™ "OPERATORS AND MAINTENANCE MANUAL"
WHICH COMES WITH EVERY NEW HEATMOR™ OUTDOOR WOOD FURNACE.
PrOBLeM
Furnace Boils
chaPter 23
MANUALS ARE AVAILABLE SEPARATELY.
cause
Draft flipper stuck open.
Draft Flipper not closing
100 percent.
Blower, Flipper Assembly
plate not tight.
Ashes holding flipper
open in air box(s).
Firebox door improperly
adjusted.
Firebox door ajar, not
shut tight.
Ash Auger tube not
sealed tight.
Top flue cover plate not
sealed.
Door gasket damaged.
sOLutiOn
Remove blower and
flipper assembly.
Clean, lube or replace.
Remove blower and
flipper assembly.
Clean, lube or replace.
Tighten wing nuts.
Clean out ashes.
Adjust Firebox Door.
Close Fire Door Tight.
Close Tube Cover
Firmly.
Tighten ½ inch nuts.
Replace Gasket.
PrOceDure
Refer to
Steps to "Maintain your Blower
and Flipper assembly."
Refer to
Steps to "Maintain your Blower
and Flipper assembly."
Refer to
Steps to "Maintain your Blower
and Flipper assembly."
Refer to
"air Box(s)."
Refer to
"Firebox Door."
Refer to
"Firebox Door."
Refer to
"ash auger tube cover Plate."
Refer to
"top rectangular Flue."
Refer to
"Firebox Door Gasket."
72