Related Manuals for Innovative Technology ITNS-500
Summary of Contents for Innovative Technology ITNS-500
- Page 1 ITNS-500 Quick Installation Guide...
- Page 3 Make sure all negative films, slide films, cover trays and photos are free of dust and dirt before inserting into the ITNS-500 as this may affect the image quality when scanning. When cleaning films, please use a professionally recommended purger from a...
- Page 4 After completing the installation, the film-scanner is ready to start with “ Image scan Tool” under program files. (WindowsXP/Vista/Windows7) It is recommended (but not required) to restart your PC after installation or un-installation. III. Using the ITNS-500 Copy button Power status LED Film/Slide...
- Page 5 Installing film into the film holder Install slide Film into the holder entitled “Slides Only” 1. Open the slide holder as illustrated 2. Place slide in recessed slot in holder 3. Close the film holder...
- Page 6 Install Negative Film into the holder entitled “Negative Film Only”: 1. Open the film holder as illustrated 2. Install film into negative film slot 3. Close the film holder...
- Page 7 Note To avoid a mirror image, follow the serial numbers (from left to right) on top of film when installing negative film into holder. Figure 1 If the image is upside down [see fig.2], the image can be corrected by ”Rotate”...
-
Page 8: Driver Installation
II. Driver Installation scanner Installation To use the ITNS-500, please complete the following installation in advance. 1. Turn on the computer 2. Insert the installation CD into the CD-ROM drive and the installation CD menu will appear 3. Click the “Installation” button to begin. - Page 9 How to use ITNS-500 Scanning Film/Slide 1. Put Film into film holder 2. Insert the film/slide backlight holder at the rear side of the ITNS-500 unit. 3. Plug in your USB cable to your PC with another side on the ITNS-500 unit.
- Page 10 4. Insert the film holder into the right side of the ITNS-500 unit 5. Click “Image Scan Tool” PC program to enter operation interface as shown below. The PC program will go into Film/Slide Mode automatically.
- Page 11 Scanning Photo 1. Remove the film / slide holder as well as the back-light holder from the ITNS-500 unit if either one is attached. Remove film /slide holder by sliding Remove back-light holder by pressing the holder to the left hand side.
- Page 12 4. Insert the photo holder into the photo slot of the ITNS-500 unit. 5. Click “Image Scan Tool” PC program to enter operation interface as shown below. The program will go into Picture Mode automatically. -10-...
- Page 13 3.Put the Business Card fixture on the top of Photo Holder. 4.Insert the entire photo holder with the business card fixture into the photo slot of the ITNS-500 unit. -11-...
- Page 14 5. Press “Copy” button or press “Snap Shot” button in the PC program to capture the image 6. Process necessary modification by using the function buttons on right hand side -12-...
- Page 15 7. Save captured images to PC 8. Get final images from PC for further review and edit -13-...
- Page 16 V. Cleaning the ITNS-500 Cleaning the backlight holder Detach the backlight holder from the ITNS-500 unit. Using the provided clean brush or a clean, dry, nonalcohol cotton swab to clean the glass surface periodically to produce a clear image during operation.
- Page 17 1 Channel Drive...
- Page 18 Instructions shall caution users that modifications not approved by the party responsible for compliance could void user's authority to operate the equipment. The following or equivalent as appropriate: “NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
- Page 20 Revision: 1.0_2...