Applicable Controls - Toshiba RAV-SM1403DT-A Installation Manual

Air conditioner (split type) indoor unit concealed duct high static pressure type
Hide thumbs Also See for RAV-SM1403DT-A:
Table of Contents

Advertisement

Concealed Duct High Static Pressure
9

APPLICABLE CONTROLS

REQUIREMENT
• When you use this air conditioner for the first
time, it takes approx. 5 minutes until the
remote controller becomes available after
power-on. This is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
on
<When power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
on
• Normal settings were made when the indoor
unit was shipped from factory.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using the
wireless remote controller, sub remote
controller, or remote-controllerless system
(for central remote controller only).
Therefore, install the wired remote controller
to change the settings.
23-EN
Approx. 5 minutes
"SETTING"
"SETTING"
flashes
goes out
Approx. 1 minutes
"SETTING"
"SETTING"
flashes
goes out
Changing of settings of for
applicable controls
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Be sure to stop the air conditioner before making
settings.)
Remote
controller
is available
4
6
Remote
controller
is available
Procedure
Push
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is
accepted for a while after
Procedure
Each time you push
numbers in the control group change cyclically.
Select the indoor unit you want to change settings
for.
The fan of the selected unit runs. You can confirm
the indoor unit for which you want to change
settings.
– 23 –
Installation Manual
1
5
2
1
button and temp. setup
button is pushed.)
(* Display content varies with
the indoor unit model.)
2
button, indoor unit
1
3
button
button to

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rav-sm1603dt-a

Table of Contents