Vacuum Operation - Toro POWERVAC 51984 Operator's Manual

2. To release the throttle lock, push throttle lock all the
way towards the front of unit.
Throttle Lock

Vacuum Operation

See Figure 14.
WARNING:
Never run the unit without the vacuum tubes
and vacuum bag installed. Failure to do so could
result in serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
1. Install the vacuum tubes, vacuum handle, and bag.
Refer to the Assembly section earlier in this manual.
2. Start the engine. Refer to Starting and Stopping earlier
in this manual.
3. Place the vacuum bag strap over your right shoulder.
Hold the upper handle in your left hand and the vacuum
handle in your right hand.
Operation
4. Move the vacuum from side to side along outer edge of
Throttle Trigger
5. Hold the engine higher than the inlet end of the vacuum
6. Always point vacuum tube downhill when working on a
7. To avoid injury to the operator or unit, do not pick up
8. If the vacuum tubes should clog, stop the engine and
9. Remove the vacuum tubes and clear the debris from
Figure 13
the debris. To avoid clogging, do not place the vacuum
tube directly into the debris pile.
tube.
hillside.
rocks, broken glass, bottles, or other similar objects.
disconnect the spark plug wire before cleaning out the
obstruction.
the blower fan housing. Remove the bag and clear the
adaptor. A small rod or stick may be required to clear
the entire tube length. Ensure that all debris has been
cleared before reassembling the vacuum tubes.
Proper Operating Position
Hold Muffler Away From Body And Clothing
Figure 14
17