Vcr Plus+ Setup (Hr-A55U Only) - JVC HR-A55U Instructions Manual

30
EN
VCR Plus+
Setup
(HR-A55U Only)
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
MENU
3
OK
1
POWER
1 2 3
2
4 5 6
7 8 9
0
4
–
+
SHUTTLE PLUS
TIMER RECORDING (cont.)
IMPORTANT
If you have moved to a different area or if a broadcasting
station's channel number has been changed, the wrong VCR
or CABLE CH number will be displayed on the VCR Plus+
program screen ( step 5 on page 29). When this happens,
perform the following steps to set the correct Guide Channel
number for that station.
To ensure that VCR Plus+Timer Recording operates correctly it
is necessary to set the VCR Plus+ "Guide Channel Set " for each
station. Please read the following information carefully.
VCR Plus+ Guide Channel Matching
The VCR Plus+ programming system assigns a VCR Plus+ "Guide
Channel" to broadcast and cable TV channels. These Guide
Channel numbers are also called the VCR Plus+ Channel Codes.
Most TV listings have a section, usually a chart, indicating the
"Guide Channel" numbers assigned to each station. For accurate
VCR Plus+ programming the VCR Plus+ Guide Channel number
for each station should match the channel number on which it is
received in your area.
NOTES:
In many instances the VCR Plus+ Guide Channel numbers for
cable and broadcast TV stations DO NOT match the channel
number on which it is received by your VCR. Check your TV
listing, or contact your cable supplier for details.
Many broadcast TV stations can be viewed on cable. Check
your TV listing, or contact your cable supplier for details.
TURN ON THE VCR
1
Press POWER.
ACCESS MAIN MENU
SCREEN
2
Press MENU.
ACCESS INITIAL SET
SCREEN
3
Press CH 5 ∞ or SHUTTLE
PLUS % fi to move the
highlight bar (arrow) to
"INITIAL SET", then press
OK or SHUTTLE PLUS
MAIN MENU
FUNCTION SET
TUNER SET
= INITIAL SET
.
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END