Rinse/Drain And Spin; Magic Clean* Lint Filter; Understanding Normal Washer Sounds - Whirlpool Two Speed Automatic Washers User & Care Manual

R /
INSE DRAIN AND SPIN
Rinse and Spin feature
When using extra detergent for heavily soiled
clothes, or washing special-care items, you may find
an extra rinse and spin is needed.
•
For an additional rinse and spin, push in the
Cycle Control knob and turn it to any of the Rinse
settings. The washer fills to the selected load
size, agitates, drains, and spins.
MAGIC CLEAN
Your washer has a MAGIC CLEAN lint filter at the
bottom of the basket. Wash and rinse water flow
over the filter during agitation, separating the lint
from the water. The lint spins out of the system
during the spin part of the cycle.
If your washer drains into a tub, remove any lint
collected in the tub or strainer.
U
NDERSTANDING NORMAL WASHER SOUNDS
Your new washer may make sounds your old one
didn't. Because the sounds may be unfamiliar, you
may be concerned about them. Don't be; most of
them are normal.
The following describes some of the sounds you
may hear and what causes them.
During washing
When you select a small load size setting, your
washer has a lower water level. This may cause a
clicking sound from the upper part of the agitator.
* LINT FILTER
Drain and Spin feature
A drain and spin may help shorten drying times for
some heavy fabrics or special-care items by
removing excess water.
•
For a drain and spin, push in the Cycle Control
knob and turn it to any of the Spin settings. Then
pull out the Cycle Control knob. The washer drains,
then spins.
MAGIC CLEAN
lint filter
During drain
If water is drained quickly from your washer
(depending on your installation), you may hear air
being pulled through the pump during the end of
draining.
After drain and before spin
When the cycle changes from draining to spinning,
you may hear gears engaging.
OPERATING YOUR WASHER
Basket
interior
9