Whirlpool Two Speed Automatic Washers User & Care Manual page 6

OPERATING YOUR WASHER
U
SING YOUR WASHER
3.
(OPTIONAL STEP) Pour measured liquid
•
To avoid spilling, use a cup with a pouring spout.
Do not let bleach splash, drip, or run down into
the washer basket.
•
Make sure you use only liquid bleach in this
dispenser.
4.
(OPTIONAL STEP) Pour measured liquid fabric
Dilute liquid fabric softener by filling the dispenser
5.
Close the washer lid.
6
.
( CONT )
bleach into the liquid
bleach dispenser.
Bleach will be diluted
automatically during the
wash part of the cycle.
•
Never use more than
250 mL (1 cup) for a full
load. Use less with a
smaller load size.
•
Follow the manufac-
turer's directions for
safe use.
softener into the
liquid fabric softener
dispenser.
•
Do not spill or drip
any fabric softener on
the clothes.
•
Make sure you use
only liquid fabric
softener in this
dispenser.
with warm water until
liquid reaches the
crossbar in the opening.
•
Softener is added
automatically during
the rinse portion of
the cycle.
6.
Turn the Load Size selector to the correct setting
different setting.
7.
Set the Water Temperature selector to the correct
detergent and ensures consistent cleaning results.
The cold wash is maintained at approximately 24°C
(75°F). The warm wash is maintained at
approximately 38°C (100°F).
NOTE: Make sure that both hot and cold water
taps are turned on, or the automatic temperature
control feature will not work properly.
•
Use the warmest water safe for fabric.
•
Follow garment label instructions.
HOT: 49°C (120°F) or above
– Whites and pastels
– Heavy and greasy soils
WARM: 32° to 44°C (90° to 110°F)
– Bright colours
– Moderate to light soils
COLD: 21° to 32°C (70° to 90°F)
– Colours that bleed or fade
8.
(OPTIONAL STEP) Your washer has an Extra
Rinse selector. For an additional rinse and spin
at the end of a wash cycle, set the Extra Rinse
selector to ON.
for your wash load and
the type of fabric being
washed.
•
Choose a load size
that allows the load to
move freely for best
fabric care.
•
Change the setting
after the washer has
started filling by turning
the selector to a
setting for the type of
fabric and soils being
washed.
•
Your washer uses
automatic temperature
control to maintain a
uniform water tempera-
ture by regulating
incoming hot and cold
water. This helps
eliminate undissolved