JVC HR - S7950EU Instructions Manual page 64

64
EN
RECORDING
SYMPTOM
1. Recording cannot be started.
2. TV broadcasts cannot be recorded.
3. Tape-to-tape editing is not possible.
4. Camcorder recording is not possible.
5. " " and " " on the front display
$
panel won't stop blinking.
TIMER RECORDING
SYMPTOM
1. Timer recording won't work.
2. Timer programming is not possible.
3. " " on the front display panel won't
#
stop blinking.
4. " ", " " and " " on the front
# $
display panel won't stop blinking.
5. " " blinks for 10 seconds and the
#
Timer mode is disengaged.
6. The S V system does not
HOW IEW
timer-record properly.
7. " " and " " on the front display
$
panel won't stop blinking.
POSSIBLE CAUSE
There is no cassette loaded, or the
cassette loaded has had its record safety
tab removed.
"L-1", "L-2", "F-1", "S-1" or "SAT" has
been selected as the input mode.
The source (another video recorder,
camcorder) has not been properly
connected.
All necessary power switches have not
been turned on.
The input mode is not correct.
The camcorder has not been properly
connected.
The input mode is not correct.
The end of the tape was reached during
recording.
POSSIBLE CAUSE
The clock and/or the timer have been set
incorrectly.
The timer is not engaged.
Timer recording is in progress.
The timer is engaged but there's no
cassette loaded.
The loaded cassette has had its record
safety tab removed.
The end of the tape was reached during
timer recording.
has been pressed when there are no
#
programs in memory, or the timer
record information has been
programmed incorrectly.
The recorder's channel positions have
been set incorrectly.
The end of the tape was reached during
Instant Timer Recording.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Insert a cassette, or using adhesive tape,
cover the hole where the tab was
removed.
Set to the desired channel.
Confirm that the source is properly
connected.
Confirm that all units' power switches are
turned on.
Set the input mode to "L-1", "L-2", "F-1"
or "S-1".
Confirm that the camcorder is properly
connected.
Set the input mode to "L-1", "L-2", "F-1"
or "S-1".
The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape to
record the entire programme.
CORRECTIVE ACTION
Re-perform the clock and/or timer
settings.
Press and confirm that "
#
on the front display panel.
Timer programming can't be performed
while a timer recording is in progress.
Wait until it finishes.
Load a cassette with the record safety tab
intact.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape to
record the entire programme.
Check the programmed data and re-
program as necessary, then press
Refer to "Guide Program Number Set"
( pg. 53) and re-perform the procedure.
The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape to
record the entire programme.
" is displayed
#
again.
#