Edit To Or From Another Video Recorder - JVC 0701MNV*ID*PJ Instructions Manual

Edit To Or
From Another
Video
Recorder
TV Receiver Player
VIDEO CHANNEL
RF Cable (provided)
Recorder
Recorder
AV Cable
(not provided)
Another recorder
Player
Your recorder
AV Cable
(not provided)
Another recorder
Your recorder TV Receiver
(MONO)
RF Cable
(provided)
You can use your video recorder as the source player or the
recording deck.
MAKE CONNECTIONS
1
Connect the player's AUDIO/VIDEO OUT connector to
the recorder's AUDIO/VIDEO IN connector.
Use the L connector for monaural connection.
SET RECORDING DECK'S
INPUT MODE
2
Set to AUX. With this video recorder, press NUMBER
key "0" and/or PR +/– to select depending on the
connector being used — "L-1" for the rear panel
VIDEO/AUDIO input connectors, or "F-1" for the front
panel VIDEO/AUDIO input connectors.
SELECT "EDIT" FOR PICTURE
CONTROL SET MODE
(MONO)
3
Follow the "Picture Control" section on page 47, then
select "EDIT."
START SOURCE PLAYER
4
Engage its Play mode.
START RECORDING DECK
5
Engage its Record mode.
NOTES:
When you use this recorder as the player for editing, be sure
to set "O.S.D." to "OFF" before starting (
All necessary cables can be obtained from your dealer.
NTSC tapes being played back in the "NTSC [ PAL" mode
( pg. 52) cannot be dubbed to another recorder.
When you dub an NTSC tape using your recorder as the
playback deck, select "NTSC 3.58" (or "NTSC 4.43") for
VIDEO
"NTSC" setting (
CHANNEL
When you select "EDIT" to dub tapes, be sure to select
"AUTO" (or "NORM" when the B.E.S.T. function is set to
"OFF") after you finish dubbing the tapes (
If you are using another recorder with S-Video and Audio
input/output connectors, you can connect those connectors to
this recorder's S-VIDEO IN/S VIDEO OUT and AUDIO IN/
OUT connectors.
When Using Your Video Recorder As The Source Player ...
... connect its rear panel S VIDEO OUT and AUDIO OUT
connectors to the recording deck's S-Video and Audio input
connectors.
When Using Your Video Recorder As The Recording Deck ...
... connect its front panel S-VIDEO and AUDIO input
connectors to the source player's S-Video and Audio output
connectors. Then, set the recorder's input mode to "S-1".
IMPORTANT:
To edit, both the player and the recorder must be of the
same colour system. Select the appropriate colour system.
( pg. 52)
For more information on multi-system compatibility,
pg. 52.
pg. 10).
pg. 52).
pg. 47).
49
EN