Continuous Drainage; Cooling Operation; Dehumidifying Operation; Fan Operation - andrews Polar Wind Operating Instructions And Safety Manual

Operating Instructions - Polar Wind
Dehumidifying and Cooling Operations
1. The operating range for dehumidifying is 10°C-30ºC (50°F-86°F) and the
operating range for cooling operating is 17°C-30°C (63°F-86°F).
2. If the cooling or dehumidifying operations have been switched off and need
switching on again in a short time, allow approximately three minutes for the
cooling or dehumidifying operations to resume.
3. Make sure the water pump drain hose is correctly connected to the unit.

Cooling Operation

1. Operating temperature range: 17ºC-30°C (63°F-86°F)
2. Press the button several times until the
3. Press the buttons to select your desired room temperature.
4. Press the button to choose the fan speed.

Dehumidifying Operation

1. Operating temperature range: 13°C-32°C (55°F-90°F)
2. Press the button several times until the
3. The fan will run at a fixed speed at this setting.
4. Keep windows and doors dosed for the best dehumidifying effect.
5. Do not put the duct to window.

Fan Operation

1. Press the button several times until the
2. Press the button to choose the fan speed.
3. Do not put'the duct to window.

Timer Operation

1. Press the button when the air conditioner is off. Select the time you
need the unit to start to operate.
2. The Operation paned window will display "On".
3. The starting time is adjustable from 00.00 to 24.

Setting the off timer:

1. Press the button when the air conditioner is on. Select the time you
need the unit to turn off. The Operation Panel Window will display "Off".
2. The turning off time is adjustable from 0.00 to 24
Water Pump Drainage
Connect the water pump drain hose to the unit before operate. When the water
level of the internal water tank reaches a predetermined level, the water pump will
be activated and drain the condensed water outside through the connected drain
hose. (Under this condition, attach the rubber bung to the back hole to prevent
continuous drainage.) Fig. 4

Continuous Drainage

When you plan to leave this unit unused for a long time, remove the rubber bung
from the back hole and attach a section of the continuous drain hose connector.
All the water In the water tank will drain outside through the drain hose. (Under
this condition, the water pump is not activated). Fig. 5.
indicator light comes on.
indicator light comes on.
Fig.2
Operating Controls
indicator light comes on.
DIGITAL DISPLAY
TEMP SETTING buttons
This button sets the present time
and timer.
INFRA RED RECEIVER
Fig.3
FAN SPEED
Indication lights.
TIMER ON/OFF buttons FAN SPEED button
Program the timer on/off function Indication light.
Click www.andrews-sykes.com
Fig.1
Drain
Water pump drain
Fig.5
COOL/DRY/FAN indicator
Press this button will choose
high, middle or low speed of air
delivery.
MODE button
Pressing this button will turn the
machine on or off.
or Call Us Free
Filter
Fig.4
WATER FULL
Indication light.
POWER
Indication light.
ON/OFF button
Pressing this button will turn the
machine on or off.
0800 211 611