Connections To A Tv Or Vcr - JVC GR-DF428 Instructions Manual

NOTES:
Before starting Blank Search, if the current
position is at a blank portion, the camcorder
searches in the reverse direction. If the current
position is at a recorded portion, the camcorder
searches in the forward direction.
If the beginning or end of the tape is reached
during Blank Search, the camcorder stops
automatically.
A blank portion which is shorter than 5 seconds of
tape may not be detected.
The detected blank portion may be located
between recorded scenes. Before you start
recording, make sure there is no recorded scene
after the blank portion.

Connections To A TV Or VCR

Open the cover.
To S connector
S cable
(optional)
1 2
TV
To AV connector
AV cable
(provided)
3 4
VCR
VIDEO PLAYBACK
A
Black to S-VIDEO IN (Connect when your TV/
VCR has S-VIDEO IN and A/V input
connectors. In this case, it is not necessary to
connect the yellow video cable.)
B
Yellow to VIDEO IN (Connect when your TV/
VCR has only A/V input connectors.)
C
Red to AUDIO R IN*
D
White to AUDIO L IN*
* Not required for watching still images only.
NOTE:
The S-Video cable is optional. Be sure to use the
YTU94146A S-Video cable. Consult the JVC
Service Center for details on its availability.
Make sure to connect the end with a core filter
to the camcorder. The core filter reduces
interference.
1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration.
If using a VCR, go to step 3.
If not, go to step 4.
3
Connect the VCR output to the TV input,
referring to your VCR's instruction manual.
4
Turn on the camcorder, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set
the TV to its VIDEO mode.
6
Start playback on the camcorder. (
To choose whether or not the following
displays appear on the connected TV
Date/time
Set "DATE/TIME" to "AUTO", "ON" or "OFF".
( pg. 27, 32)
Or, press DISPLAY on the remote control to turn
on/off the date indication.
Time code
Set "TIME CODE" to "ON" or "OFF".
( pg. 27, 32)
Indications other than date/time and time code
Set "ON SCREEN" to "OFF", "LCD" or "LCD/TV".
( pg. 27, 32)
NOTES:
It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
( pg. 15)
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's Power Switch to "A" or "M", then set
your TV to the appropriate input mode.
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
23
EN
pg. 22)