Vertical Wall Exit Using 6"Single Wall Pipe And Elbow/Listed 2100° Ul 103 Ht Chimney And T-Box Assembly With Close Clearance Shields - New Buck Corporation LITTLE JOHN Installation & Operation Manual

Vertical wall exit using (6" Single Wall minimum 24 ga. blued or black
pipe , with elbow, and any listed 2100° UL 103 HT. TYPE Chimney
BACK WALL BACK WALL
10"
B
B
E
E
A
A
NOTE: All clearances are to combustibles using 6" Single Wall minimum 24 ga. blued or black pipe with
elbow, and minimum floor protector, with close clearance shields. Going thru wall, floor protector must be
minimum 10" wide all the way to wall. Clearances above may be reduced. Follow NFPA-211 codes if
available or follow instructions on (Page 19).
NOTE:
CEILING
SINGLE WALL CONNECTOR
CENTER LINE
OF ELBOW
MARK PLUMB
LINE ON WALL
Figure 17
PROTECTOR PAD
SECTION G.
and Listed 2100° UL HT. T-Box assembly).
With close clearance shields.
F
H F
D
G
A B
19" 16" 16" 26.25" 8"
D
G
Maintain 18" Minimum Clearance
PIPE WITH ELBOW
Figure 16
C D E F G
8" 16"
LISTED 2100° UL 103 HT TYP.
INSTALLATION INSTRUCTION
WALL
PASS-THROUGH
CONNECTOR
IN
SIDE
Connect with (3) sheet
WALL
metal screws or rivets to
connector collar on heater.
CLOSE
CLEARANCE
SHIELD
Page 18
C C
C
C
CHIMNEY REEFER TO
MANUFACTURES
LISTED 2100° UL 103 HT
TYP. CHIMNEY T-BOX
ASSEMBLY REEFER TO
MANUFACTURES
INSTALLATION
INSTRUCTION