JVC UX-V6V Instructions Manual page 6

CAUTION: Make all connections before plugging the Unit into an AC power outlet.
Connecting the FM/SW Antenna
Using the Supplied Wire Antenna
Rear Panel of the Unit
OPTICAL
DIGITAL OUT
L
R
R L
Using an FM 75-Ohm Antenna Wire (not Supplied) and SW (7-21.85 MHz) Antenna Wire (not Supplied)
If reception is poor, connect the outdoor antenna.
Rear Panel of the Unit
OPTICAL
DIGITAL OUT
L
R
R L
Connecting the AM/SW Antenna
Rear Panel of the Unit
OPTICAL
DIGITAL OUT
L
R
R L
CAUTION: To avoid noise, keep antennas away from the System, the connecting cord and the AC power
cord.
3
FM/SW (7-21.85MHz) Wire Antenna
FM/SW
75
FM EXT
AM
LOOP
AM EXT
Outdoor SW (7-21.85MHz) antenna wire
FM/SW
75
FM EXT
AM
LOOP
AM EXT
AM/SW (2.3-6.995MHz) Loop Antenna
FM/SW
Note: Even when connecting an outdoor AM an-
75
tenna, keep the indoor AM/SW loop con-
FM EXT
nected.
AM
LOOP
AM EXT
AM/SW (2.3-6.995MHz) antenna wire (not supplied) if reception is poor,
connect the outdoor antenna.
Extend the supplied FM/SW
Wire Antenna horizontally.
Strip vinyl shield from cut line,
twist wire core.
20 mm 10 mm
Outdoor FM antenna wire
Note: Before attaching a 75 ohm coaxial lead (the kind with a
round wire going to an outdoor antenna) or an outdoor SW
antenna, disconnect the supplied FM/SW Wire Antenna.
Turn the loop until you
have the best reception.
Attach the AM/SW Loop to
its base by snapping the
tabs on the loop into the
slot in the base.