A.2 Watchdog Timer Control Register
The Watchdog Timer Control Register controls the EDT working mode. Write the value to
the WDT Configuration Port. The following table describes the Control Register bit
definition.
Table A-2: Control Register Bit Definition
A.3 Watchdog Timer Programming Procedure
Power on or reset the system
The initial value of WDT Control Register (D4~D0) is zero, when power is on or reset the
system. The following shows the initial value of WDT (00000000b):
Table A-3: WDT Control Register Initial Value
D E L T A
C O M P O N E N T S
G m b H
Auweg27, D-79761 Waldshut-Tiengen Seite - 59 -