board. The board contains two memory banks: Bank 0 and 1, which correspond to connector
DIMM1 and DIMM2. The table below shows possible DIMM Configurations for the memory
banks. Please note that the System Board supports Double Data Rate DDR 200/266/333
SDRAM. Configurations using different brands of memory modules are not recommended.
Table 3-1: DIMM Configurations of the System Board
3.2 Installing DIMM
To install DIMM
1. Make sure the two handles of the DIMM sockets are in the "open" position, i.e. the handles
stay outward.
Figure3-1: How to Install DIMM (1)
2. Slowly slide the DIMM modules along the plastic guides in the both ends of the socket.
D E L T A
C O M P O N E N T S
G m b H
Auweg27, D-79761 Waldshut-Tiengen Seite - 34 -