JVC UX-G500V Instructions Manual page 8

Jvc micro component system instructions manual
Hide thumbs Also See for UX-G500V:
Table of Contents

Advertisement

~
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
AM loop antenna (supplied)
Turn it until the best reception is obtained.
If the cords are covered with vinyl,
remove the vinyl to expose the tip of the
cord by twisting the vinyl.
FM antenna (supplied)
Extend it so that you can obtain the
best reception.
For better FM reception
Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75 Ω wire with coaxial type
connector.
5
Ÿ
• When connecting the speaker cords, match the polarity
of the speaker terminals: red to (+) and black to (–)
From right
speaker
!
FM outdoor antenna
(not supplied)
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO"
menu correctly according to the connected digital audio
equipment (see page 37).
• The digital signal through the OPTICAL DIGITAL OUT
terminal is transmitted only when "DVD/CD" is selected
as the source.
Speakers
Insert
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom of
the speakers.
Digital audio component
Protective cap
Press and hold
Release
Red
Black
From left
speaker
Optical digital
cord (not
supplied)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Uxg50 - cd microsystem with usb audio

Table of Contents