Yamaha YZ250F Owner's Service Manual page 199

TRANSMISSION, SHIFT CAM AND SHIFT FORK
c
2. Install:
NOTE:
• Apply the molybdenum disulfide oil on the
• Apply the lithium soap base grease on the O-
3. Install:
NOTE:
• Be sure the circlip sharp-edged corner a is
• Install the circlip with its ends c settled
c
4. Install:
NOTE:
• Apply the lithium soap base grease on the oil
• When installing the collar into the crankcase,
4 - 99
• 2nd wheel gear (28T) 1
• 4th wheel gear (27T) 2
• 3rd wheel gear (29T) 3
• 5th wheel gear (25T) 4
• 1st wheel gear (30T) 5
• O-ring 6
To drive axle 7.
inner and end surface of the idler gear and
on the inner surface of the sliding gear, then
install.
ring.
• Washer 1
• Circlip 2
positioned opposite side to the washer and
gear b.
evenly on the spline crests.
• Collar 1
seal lip.
pay careful attention to the crankcase oil seal
lip.
ENG