Clever Choice Auto-Code Blood Glucose MonitoringSystem Owner's Manual page 31

STEP 4 Apply blood into the test strip
When " " is flashing on the screen, apply your
blood to the absorbent hole of the test strip
until the confirmation window is fully covered
with blood. The meter then begins to count
down automatically.
STEP 5 Obtain an Accurate Result
in 7 Seconds
The result of your blood glucose test is shown
after the meter counts to 0. This reading is au-
tomatically stored in the meter.
PLEASE NOTE
Do not push your finger (with blood on it) against the test strip
or try to apply a smeared sample on the test strip.
If you do not apply a blood sample to the test strip within 3 min-
utes, the meter will automatically turn off. You must remove and
reinsert the test strip to restart the test procedure.
The blood should be completely filled the confirmation window
before the meter begins to count down. If you find that the
confirmation window is not filled with blood when the meter is
counting, NEVER try to add more blood to the test strip. Dis-
card the test strip and retest with a new one.
If you have trouble filling the test strip, please contact the cus-
tomer service for help.
31