Indoor Unit Installation - Midea MSE18HRN1 Installation Manual

Indoor unit installation

1. Fit the Installation Plate
1. Fit the installation plate horizontally
on structural parts of the wall with
spaces around the installation plate.
2. If the wall is made of brick, concrete or
the like, drill eight (8) 5mm diameter holes
in the wall. Insert Clip anchor for appropriate
mounting screws.
3. Fit the installation plate on the wall with eight
(8) type "A" screws.
Note:
Fit the Installation Plate and drill holes in the wall according to the wall structure
and corresponding mounting points on the installation plate.
(Dimensions are in "mm" unless otherwise stated)
Indoor unit outline
120mm or more
to wall
45
Left rear side
refrigerant
pipe hole 65
Indoor unit outline
120mm or more
to wall
45
Left rear side
refrigerant
pipe hole 65
2. Drill a hole in the wall
1. Determine hole positions according to
the diagram detailed in Fig.5. Drill
one (1) hole ( 65mm) slanting slightly
to outdoor side.
2. Always use wall hole conduit when
drilling metal grid, metal plate or the like.
150mm or more to ceiling
790
(<12000Btu/h model)
150mm or more to ceiling
920
( 12000Btu/h model)
Fig.5
INSTALLATION INSTRUCTIONS
Correct orientation
of Installation Plate
Installation plate
120mm or more
to wall
90
Right rear side
refrigerant
pipe hole
Installation plate
120mm or more
to wall
90
Right rear side
refrigerant
pipe hole
Indoor
5
Fig.4
65
65
Wall
Outdoor
Fig.6