Toshiba e-studio166 Service Handbook page 171

[E73] Stop jam at the exit sensor
Is the exit roller stained?
YES
NO
Is the exit sensor working? (Perform the input check: 03-[INTERRUPT]ON/[2]/[2])
l NO
l
l
l
l
l
l
l
YES
Replace the ADF board.
[E86] ADF jam access cover open
Is the ADF jam access cover opened?
YES
NO
Is the ADF jam access cover switch working?
(Perform the input check: 03-[INTERRUPT]ON/[4]/[4])
l NO
l
l
l
l
l
l
l
l
YES
Replace the ADF board.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Clean the roller.
1) Check if the connector of the exit sensor is disconnected.
2) Check if the connector CN75 on the ADF board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are
open circuited.
4) Check if the conductor pattern on the ADF board is short circuited or
open circuited.
5) Replace the exit sensor.
6) Replace the ADF board.
Remove the original, if any, and close the ADF jam access cover.
1) Check if the connector of the ADF jam access cover switch is discon-
nected.
2) Check if the connector CN75 on the ADF board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are
open circuited.
4) Check if the conductor pattern on the ADF board is short circuited or
open circuited.
5) Replace the ADF jam access cover switch.
6) Replace the ADF board.
5 - 11
e-STUDIO163/166/203/206
TROUBLESHOOTING
5