Toshiba e-studio166 Service Handbook page 101

[F] Right margin
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [4] [INTERRUPT]
[START] (A solid black pattern (whole area) is printed out. Print out 2 sheets in A3/LD size.).
(3) Place the paper printed out in step (2) to cover the whole area of the original glass.
(4) Press [0] and [9] simultaneously to enter the normal mode.
(5) Make a copy at the mode of A3/LD, 100%, Text/Photo and standard drawer of the equipment.
(6) Press [0] and [5] simultaneously to enter the adjustment mode.
(7) Measure the blank area F at the right side of the copied image.
(8) Check if the blank area F is within the range of 2±1.0 mm.
(9) If not, use the following procedure to change values and repeat the steps (4) to (8) above.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
Press the [INTERRUPT] button (stored in memory).
*The larger the adjustment value is, the wider the blank area at the right side becomes (approx.
0.04 mm/step).
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
[PAPER FEED] (Select from 0: bypass, 1: drawer or 2: PFU.)
(Key in the code [432])
Feeding direction
Fig. 3-13
3 - 17
06/04
(Adjustment Mode)
[START]
("AJ" is displayed.)
F
e-STUDIO163/166/203/206
ADJUSTMENT
3