Swing Arm; Swing Arm Removal; Swing Arm Installation - Scorpa SY-250FR 2008 Manual Manual

13 Swing arm

13.1 Swing arm removal

Remove the rear wheel (see « rear wheel

removal »).
Remove the license plate support (see "side

covers removal").
Remove the quick disconnect fastener.

Unscrew the brake hose holder bolt.

Unscrew the swing arm axle and remove it.

Remove the swing arm.

Unscrew the sprocket drive cover bolts.

Unscrew the chain guard bolts and remove the

chain guard.
Unscrew the chain puller fixing bolts.

Unscrew the chain puller spring bolts, remove

the chain puller spring.
Unscrew the eccentric stop bolt.

Unscrew the driven sprocket protective plate

nuts.
Remove the protective plate bolts then remove

the protective plate.
Unscrew the rear brake calliper stop.

Unscrew the chain cover fixing bolt and nut,

remove the bolt then remove the chain cover.
21

13.2 Swing arm installation

Install the chain cover and the fixing bolts.

Screw the chain cover nut and bold (use soft

locking agent on the bolt).
Screw the rear brake calliper stop and the nut.

Install the protective plate with the fixing bolts.

Screw the chain cover nuts.

Screw the eccentric strop bolt (use hard

locking agent).
Install the chain puller and screw the chain

puller spring fixing bolt (with hard locking
agent).
Lubricate the chain puller spacer and screw the

chain puller fixing bolt.
Install the chain guard seal and screw the

fixing bolts.
Install the sprocket drive cover and screw the

fixing bolts.
Lubricate the swing arm bearings.

Install the swing arm and install the axle (by

the left side).
Screw the rear wheel axle nut.

Install the chain.

Install the rear wheel (see "rear wheel

installation").
Install the license plate support (see "side

covers installation")