Chevrolet 2008 Corvette Owner's Manual page 42

Securing a Child Restraint with a Top Tether
CAUTION:
{
If a LATCH-type child restraint is not attached
to anchors, the child restraint will not be able
to protect the child correctly. In a crash, the
child could be seriously injured or killed.
Install a LATCH-type child restraint properly
using the anchors, or use the vehicle's safety
belts to secure the restraint, following the
instructions that came with the child restraint
and the instructions in this manual.
1. Secure the child restraint using the vehicle's safety
belt. See Securing a Child Restraint in the Right
Front Seat Position on page 1-39.
2. If the child restraint manufacturer recommends that
the top tether be attached, attach and tighten the
top tether to the top tether anchor, if equipped.
Refer to the child restraint instructions and
the following steps:
2.1. Find the top tether anchor.
2.2. Press the ribbed area of the trim cover to
open the cover and expose the anchor.
1-38
2.3. Route, attach and tighten the top tether
according to your child restraint instructions
and the following instructions:
3. Push and pull the child restraint in different
directions to be sure it is secure.
If the position you are
using has a fixed headrest
or head restraint and
you are using a single
tether, route the tether over
the headrest or head
restraint.
If the position you are
using has a fixed headrest
or head restraint and
you are using a dual tether,
route the tether around
the headrest or head
restraint.