JVC GVT0125-003A Instructions Manual page 8

To assemble and connect the AM loop antenna
To assemble the AM loop antenna
To connect the AM loop antenna cords
1 Hold
2 Insert
• If the AM loop antenna wire or speaker cords are covered with
vinyl, remove the vinyl to expose the tip of the antenna by
twisting the vinyl.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System, connecting
cords, and the AC power cord. This could cause poor
condition.
6
3 Release
To connect the speaker cords
1 Hold
2 Insert
From right
speaker
From
right Subwoofer
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
Speaker
(+)
Main speakers Blue
Subwoofers Red
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom of
the speakers.
3 Release
From left
speaker
From
left Subwoofer
Terminal color
(–)
Black
Black