Bissell 8920 User Manual page 13

Post-Treatment Scotchgard Protector (Optional)
Purge the hose to eliminate cleaning solution from
2.
the tube by spraying clean water through the hose
without attachments into a sink for 15-30 seconds.
Attach Scotchgard post-applicator cartridge to the
3.
Applicator Tool, following the instructions on the
cartridge. Attach the combined Tool/Cartridge to
the hose. The water from the 2-in-1 Tank will
automatically mix with the concentrated Scotchgard
post-treatment formula contained in the cartridge.
Turn the Custom Clean Dial to the
4.
Rinse/Protect setting.
Before applying Scotchgard protector to a large
5.
area, test in a small, hidden area for colourfastness.
Examine area when dry. If colour is affected, do not
use. For use on upholstery, look for manufacturer's
cleanability code tag. Use only on fabrics coded
"W" or "WS". If coded "S" or "X", do not use. Not
recommended for use on velvet, silk vinyl, leather,
or 100% cotton upholstery.
Apply Scotchgard protector in a slow sweeping
6.
motion with a slight overlap of the treated area. For
best coverage, follow the guide on the cartridge.
One 8 oz (236 mL) cartridge protects 200 ft
7.
2
(18.6 m ). This is equal to two average size
rooms, (each at 10 x 10 ft or 3 x 3 metres).
Periodically check the level in the bottle to
ensure the best coverage.
Be careful not to spray the protector onto furniture
8.
or fabric that has not been tested for colourfast-
ness. If this does occur, wipe off the protector.
Remove the bottle from the spraying applicator tool.
9.
If concentrate is left, replace the cap to the cartridge
and store at room temperature for later use.
With the applicator tool still on the end of the
10.
hose, spray clean hot water into the sink to avoid
any future clogging.
Store tool in a convenient location for use the
11.
next time.
2
Tip:
If clogged, soak
2 applicator tool
in hot tap water
before using.
13 16