Advertisement
4.3 When to recharge the Battery?
Indication, when the red LED flashes per 5s, iX‐B24 needs to be recharged. Important: The
rechargeable battery must be disposed or recycled according to local ordinance regulations.
5 Powering
The power and paring button is called PAP in this manual. It's function depends on how long you
keep the button pressed. A short press is less than a second. A long press is two to five seconds (as
indicated in this manual).
1. Standby mode Long press (about 2 seconds) PAP until LED flashed blue.
2. Pairing mode long press (about 5 seconds) PAP until the LED flashes red/blue (after about 3
seconds [standby]: keep the button pressed until the LED flashes red/blue)
3. Turn off the iX‐B24, long press (about 5 seconds) PAP until the LED flashes red five times. Then
release PAP. The iX‐B24 will be turned offo.
6 iX‐B24 Indicator Lights
State
Power off
Pairing mode
Pairing successful
Standby (no audio channel)
Standby (audio audio channel open) Flash 3 times in 500ms, then long off 2s OFF
Standby (low battery)
Active mode (low battery)
Charging mode
7 Pairing
1. To put the headset in pairing mode, please review it's manual.
2. To put the dongle in pairing mode, long press (about 5 seconds) PAP until the LED flashes red/blue,
release the button.
3. The headset can pair with the Audio dongle automatically. Both devices should flash blue (iX‐B24
flash 3 times in 500ms then long off 2s) when paired successfully. Then you can hear music from your
headset after your shorting press the MFB button.
Important if devices are not pairing, iX‐B24 will enter into standby mode (only flash blue) in one
minute. In this case pairing procedure should be repeated.
LED indicator
Blue LED
OFF
Flash
Flash 3 times
Flash 1 time every 2s
Flash 1 time every 2s
Flash 3 times in 500ms, then long off 2s Flash 1 time every 5s
According to status
Red LED
OFF
Flash
OFF
OFF
Flash 1 time every 5s
On unit charging is over
Advertisement
