Sanyo LCD-42K40TD Service Manual page 12

Service Adjustments
ADC ADJUST
r
1. Enter the Service Mode.
2. Select "ADC ADJUST" by pressing ▲ or ▼ button, then press OK button to enter ADC ADJUST menu.
ADC ADJUST
SOURCE : SOURCE :
R-GAIN :
G-GAIN :
B-GAIN :
R-OFFSET :
G-OFFSET :
B-OFFSET :
AUTO ADC
3. Press ▲ or ▼ button to select "SOURCE" item, press ◄ or ► button to select RGB, YPbPr(SD) or
YPbPr(HD).
RGB
(1). Receive signal from PC input. And set ANSI pattern contrast in PC mode. Receive signal from PC input. And set ANSI pattern contrast in PC mode.
(2). Enter the ADC ADJUST menu. Press Enter the ADC ADJUST menu. Press
(3). Press ◄ or ► button to select RGB.
(4). Press ▲ or ▼ button to select AUTO ADC item, then press OK button.
YPbPr (SD)
(1). �eceive 100% Colour �ar from 480p and 57�p singal in ��b�r input. �eceive 100% Colour �ar from 480p and 57�p singal in ��b�r input.
(2). Enter the ADC ADJUST menu. Press
Enter the ADC ADJUST menu. Press
(3). Press ◄ or ► button to select YPbPr (SD).
(4). Press ▲ or ▼ button to select AUTO ADC item, then press OK button.
YPbPr (HD)
(1). �eceive 100% Colour �ar from 1080p, 1080i and 720p singal in ��b�r input. �eceive 100% Colour �ar from 1080p, 1080i and 720p singal in ��b�r input.
(2). Enter the ADC ADJUST menu. Press Enter the ADC ADJUST menu. Press
(3). Press ◄ or ► button to select YPbPr (HD).
(4). Press ▲ or ▼ button to select AUTO ADC item, then press OK button.
4. Exit the Service Mode.
Wait for about several seconds until AUTO ADC adjust completed. Then press MENU button to exit.
Note: If you want to adjust any item, please consult qualified service personnel.
1
RGB RGB
117
121
123
131
145
123
FAIL
Press ▲ or ▼ button to select "SOURCE" item
Press ▲ or ▼ button to select "SOURCE" item.
Press ▲ or ▼ button to select "SOURCE" item.