Table of Contents
Advertisement
CD Messages
CD message
CANNOT PLAY
You are trying to play back an unplayable CD or
a CD that has many scratches.
CD NO DISC
No CD is loaded.
Troubleshooting
Check the following points before contacting the JVC service center.
Problem
No sound is produced
from the speakers.
The clock display is
flashing.
CD playback does not
start.
A certain point cannot be
played back properly.
Certain tracks on an MP3
disc cannot be played
back.
The volume of cassette
tape playback is low.
You cannot record
cassette tape playback.
A radio broadcast cannot
be received.
A whirring noise is
produced.
The timer does not
function.
You cannot operate the
remote control.
Operations are disabled.
When you turn on the
main unit, a noise comes
out from the rear of the
main unit.
Meaning
Possible cause
Improper connection.
Headphones are connected.
The MP3 disc is recorded utilizing
"packet writing".
The main unit is turned off
because of a power cut. The
power plug is disconnected.
The CD is upside down.
Moisture has condensed on the
lens.
The CD is scratched or dirty.
These tracks were recorded in a
format other than MP3 format.
The head or capstans are dirty.
The cassette tape is write-
protected.
No antenna is connected.
The main unit is located close to a
TV, computer, or other electric
appliance.
You did not set the clock.
The main unit is turned on.
The remote control batteries are
running low.
The built-in microprocessor may
malfunction due to external
electrical interference.
The internal cooling fan produces
the noise as it rotates.
Possible solution
Replace the CD.
Place a CD on the CD tray.
Possible solution
Connect all cords properly as in
"Connections".
Disconnect the headphone plug.
This product cannot play back this type
of MP3 disc. Replace the disc.
Reset the clock.
Place the CD on the CD tray with the
letter-printed surface facing up.
Leave the main unit turned on, wait for
approximately 1 or 2 hours, and then
operate the main unit.
Clean or replace the CD.
This product cannot play back this type
of MP3 disc. Replace the disc.
Clean the head or capstans.
Cover the write protect tag holes on the
cassette tape with adhesive tape.
Connect an antenna.
Place the main unit away from a TV,
computer, or other electric appliance.
Set the clock.
After setting the timer, turn off the main
unit.
Replace the batteries with new
batteries.
Disconnect the power plug, and then
connect it back in.
The noise is not a malfunction. This is
to prevent excessive heat.
Reference
page
8
4
–
10
16
2
27
–
27
21
6, 7
2
10
24, 25
5
–
8, 11
28
Advertisement
Table of Contents
