Cylinder Head And Valve - Nanni N3.30 Workshop Manual

05-E3B, 05-E3BG, WSM

(3) Cylinder Head and Valve

Cylinder Head Cover
1. Disconnect the breather hose (1).
2. Remove the cylinder head cover screw (2).
3. Remove the cylinder head cover (3).
(When reassembling)
• Check to see if the cylinder head cover gasket is not defective.
[D1005-E3B / E3BG, D1105-E3B / E3BG, D1105-T-E3B,
V1505-E3B / E3BG, V1505-T-E3B]
Tightening torque Cylinder head cover screw
[D1305-E3B / E3BG]
Tightening torque Cylinder head cover screw
(1) Breather Hose
(2) Cylinder Head Cover Screw
(3) Cylinder Head Cover
Injection Pipes
1. Loosen the screws to the pipe clamp (1).
2. Detach the injection pipes (2).
(When reassembling)
• Send compressed air into the pipes to blow out dust. Then,
reassemble the pipes in the reverse order.
Tightening torque Injection pipe retaining nut
(1) Pipe Clamp
S-31
DIESEL ENGINE
7 to 8 N·m
0.7 to 0.9 kgf·m
5 to 6 lbf·ft
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
[A] D1005-E3B / E3BG,
D1105-E3B / E3BG, D1105-T-E3B,
V1505-E3B / E3BG, V1505-T-E3B
[B] D1305-E3B / E3BG
W1085242
25 to 34 N·m
2.5 to 3.5 kgf·m
18 to 25 lbf·ft
(2) Injection Pipe
W1028640
KiSC issued 12, 2007 A