Jayco 2014 PINNACLE TOWABLES RV User Manual page 31

JAYCO TOWABLE
The carbon monoxide detector installed is intended for use in ordinary
indoor locations of recreation vehicles. It is not designed to comply with
Occupational Safety and Health Administration (OSHA) commercial or
industrial standards.
Do not disconnect the battery or the alarm.
Individuals with medical problems may consider using warning devices that
provide audible and visual signals for carbon monoxide concentrations
under 30 PPM.
This alarm will only indicate the presence of carbon monoxide gas at the
sensor. Carbon monoxide gas may be present in other areas.
The ultimate responsibility for protection against toxic carbon monoxide
fumes rests solely on you. Installing a carbon monoxide/propane alarm is
just the first step in protecting your family from toxic carbon monoxide
poisoning
What you should do if the alarm sounds
Actuation of this detector indicates the presence of carbon monoxide which
can kill you.
1. Operate the RESET/SILENCE button.
2. Call your emergency services (fire department or 911).
3. Immediately move to fresh air (outdoors or by an open door or window)
4. Do not re-enter the premises or move away from the open door or window
until the emergency service responders have arrived, the premises have
been aired out, and your alarm remains in its normal condition.
If your alarm reactivates within a 24-hour period, repeat steps 1-4 and call a
qualified appliance technician to investigate for sources of carbon monoxide from
fuel burning equipment and appliances, and inspect for proper operation of this
equipment. Make sure that motor vehicle(s) are not, and have not been, operating
in an attached garage or adjacent to the RV.
If problems are identified during this inspection, have the alarm serviced
immediately. Note any combustion equipment not inspected by the technician and
consult the manufacturer's instructions or contact the manufacturer directly for
more information about carbon monoxide safety and this alarm.
Alarm Signals
Normal Operation: The LED will maintain a steady green light, indicating

that the alarm is powered.
CO alarm condition: The red LED light will remain steady and the alarm will

sound 4 "BEEPS" then silent for 5 seconds.
immediate action is required.
Propane gas alarm: The red LED light will flash and the alarm will sound a

steady tone. These signals indicate immediate action is required.
SECTION 2 - OCCUPANT SAFETY
WARNING
WARNING
These signals indicate
2-5