Jayco 2014 PINNACLE TOWABLES RV User Manual page 108

SECTION 12 - INTERIOR
J-S S (I
TEEL OFA
The J-steel sofa functions much the same as a residential futon. To make the J-
steel sofa in to a bed, lift up on the bottom seat cushion and pull it towards you.
The sofa back will drop down to provide a sleeping surface. For additional comfort
and to reduce fabric damage, you may want to place a cover or air mattress
(customer supplied) over the J-steel sofa when it is in the sleeping position
F -S
REE TANDING
The free-standing dinette table can be positioned to seat up to four people. To
prevent damage, the standard free-standing dinette chairs should be fastened
securely at the dinette table when you are traveling
B D
OOTH INETTE
The dinette is designed to seat up to four adults. You can access the dinette
bench storage by removing all the cushions and lifting the bottom seat supports. If
the dinette bottom seat support is screwed shut, it is to protect factory-installed
equipment (do not use that area for storage). To convert back to a booth dinette,
reverse the process.
The booth dinette can be converted into a bed. To convert, remove all the
cushions from the booth dinette. Lift the tabletop, remove the detachable table
legs and place the tabletop on the ledges provided between the booth dinette
benches.
Lay the seat back cushions against the back of the booth dinette bench. Lay the
dinette seat bottom cushions in between the seat back cushions. The area where
the cushions meet should be slightly raised. Push the raised cushion ends down
gently. The cushions are designed to fit snugly. Reverse this process when
converting back to the booth dinette.
Extendable dinette (if so equipped)
Your travel trailer may be equipped with side extensions on the dinette benches
that can be used only when the slideout is extended.
1. Remove the snap strap (located at the back of
the dinette bench) that secures the extensions in
the travel position.
2. Pull out the dinette bench extension until it hits
the factory-installed stops.
3. Remove the seat, seat back cushion and plywood
seat extender
compartment (put the cushions off to the side).
4. Position the plywood seat extender across the
dinette bench extension brackets. The plywood
seat extender MUST be in place to use the extendable dinette.
5. Place the seat and seat back cushions on the extensions and repeat the
process for the other dinette bench extension.
To close the extendable dinette, reverse the process. The extendable dinette must
be closed, the snap strap secured and the tabletop put in the bed position
BEFORE the slideout room is retracted for transit.
12-4
S E )
F O QUIPPED
T & C
ABLE HAIRS
(I S E
F O QUIPPED
from the
(I S E
F O QUIPPED
)
revealed storage
JAYCO TOWABLE
)
Fig. 12.1 Extendable
dinette
.