Toyota 2003 HIGHLANDER User Manual page 172

6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
R
maining HomeLink button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
R
Individual HomeLink buttons cannot be
erased, however, to reprogram a single
button, follow the procedure "Programming
R
the HomeLink ".
R
(b) Operating the HomeLink
R
To operate the HomeLink , press the
R
appropriate HomeLink button to activate
the programmed device. The HomeLink
indicator light should come on.
R
HomeLink continues to send the signal
for up to 20 seconds as long as the
button is pressed.
172
'03 HIGHLANDER_U (L/O 0208)
R
by (c) Erasing the entire
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
R
The
R
HomeLink
CAUTION
z
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
R
rage door or other device to pre-
vent potential harm or damage.
z
Do not use this HomeLink
sal Transceiver
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
2003 HIGHLANDER from Aug. '02 Prod. (OM48441U)
R
R
Univer-
with any garage
any garage door