Table of Contents
Advertisement
3.3 Installation in 19" Racks
3.3.1 G
ENERAL
The Local Mux-6 can be installed in a 19" rack. Its height is slightly less than
1U (1.75"), and the width is slightly less than the available mounting width.
Disconnect the units from mains power while performing the following
procedures. If you don't, you could be shocked!
3.3.2 I
NSTALLATION OF A
The rack adapter components for single-unit installation include two short
brackets. The brackets are fastened by means of screws to the side walls for
the case, as shown in Figure 3-2. The brackets are attached to the two side
walls of the unit.
1. To prepare the unit for rack installation, attach the two brackets to the
side walls of the unit. Each bracket is fastened by means of two screws
(with flatwashers), which are inserted into the two front holes on the
wide wall (nuts are already in place, on the inner side of the wall).
2. After attaching the brackets, the unit is ready for installation in the
19" rack. Fasten the brackets to the side rails of the 19" rack by means
of four screws—two per side.
WARNING
U
NIT
LOCAL MUX-6
15
Advertisement
Table of Contents
