SERVICE INFORMATION FOR EEPROM IC SETTING
MICOM START
EEPROM ID CHECK
2 BYTE(B3,248,249)
No
ID OK?
Yes
No
OPTION DATA READ
5TIME & COMPARE
Yes
MICOM NORMAL
OPERATION START
*** EEPROM INITIAL ***
- SETUP is displayed in the field if pressing the Front ch- & ch+ Key with the Remocon number "clear"
key pressed in the status of powering on.
- AUTO SEARCH is done since the initial screen of ACMS is serviced if powering on.
DETECT NEW EEPROM (OPTION EDIT SCREEN)
NAME HEX
BINARY
OPT1
11
00000000
OPT2
50
00000000
OPT3
10
00000000
OPT4
00
00000000 (reserved)
OPT5
00
00000000 (reserved)
OPT6
00
00000000 (reserved)
WRITE:OK
EXIT:MENU,MP
MOVE:< >
EDIT : __
OPTION WRITE : OK
(OK KEY IN)
MASK : R00 , EEP : R00 , (D10)
(Each mask ,eeprom, It shows a development release
version.)
OPTION condition of Present time
the CHECK There is a Possibility of
doing and the OPTION the REWRITE
it is possible.
1-6
OPTION CONFIRMATION MODE
Press the "CLEAR" key on the
Remote controller and the "CH - " key
one the Front Panel the same
time, then it goes in to Tracking
initial mode.