Replacing The Oven Door; Replacing The Storage Drawer - GE JSS28 Installation Instructions Manual

REPLACING THE OVEN DOOR

4
NOTE: The oven door is heavy. You may need
help lifting the door high enough to slide it
into the hinge slots. Do not lift the door by
the handle.
A Lift the oven door by
placing one hand on each
side. The door is heavy, so
you may need help. Do not
lift the door by the handle.
With the door at the same angle as the
B
removal position (halfway between the
closed and broil stop position), seat the
notch of the hinge arm into the bottom
edge of the hinge slot. The notch of the
hinge arm must be fully seated into the
bottom of the slot.
Bottom
edge of slot
Hinge notch
Open the oven door as far as it will open.
C
D Push the hinge locks up
against the front frame of
the oven cavity, to the
locked
Notch of hinge
position.
securely fitted
into bottom of
hinge slot
E Close the oven door.
Installation Instructions
Hinge arm
Hinge in locked
position
REPLACING THE STORAGE
5
DRAWER
A Place the drawer
rail on the
guides.
B Push the drawer
in until it stops.
Lift the front of
C
the drawer and
push in until the stops clear the guides.
Lower the front of the drawer and push in
D
until it closes.
SPECIAL INSTRUCTIONS IF YOU ARE
HAVING PROBLEMS WHILE REPLACING
THE STORAGE DRAWER
If drawer won't close:
Drawer does
not close
completely
Power cord may
be obstructing
drawer in this area
Remove and replace, making sure the power
cord is not obstructing the drawer and/or the
rail is in the guide.
If drawer is crooked:
Rear drawer
support is on top
of guide rail on
the high side
Remove and replace, making sure the rail is in
the guide.
11
Stop
Drawer front
panel tipped
away from
Rear drawer
body side
support is
resting on top
of guide rail
Drawer front panel
tipped to one side