Replacing The Oven Door - GE PGS908DEP4WW Installation Instructions Manual

REPLACING THE OVEN DOOR
NOTE: The oven door is heavy. You may need help lifting the door high enough to
slide it into the hinge slots. Do not lift the door by the handle.
A. Lift the oven door by placing one hand on each side. The door is heavy, so you
may need help. Do not lift the door by the handle.
B. With the door at the same angle as the removal position (approximately 1"-2"
[2.5 cm-5.1 cm] from the closed position), seat the notch of the hinge arm into the
bottom edge of the hinge slot. The notch of the hinge arm must be fully seated
into the bottom of the slot.
C. Fully open the door. If the door will not fully open, the indentation is not seated
correctly in the bottom edge of the slot.
D. Push the hinge locks up against the front frame of the oven cavity, to the locked position.
E. Close the oven door.
Hinge in
locked
Notch of hinge
securely fitted /
into bottom
of hinge slot
Bottom edge
_1!_I of slot Hinge arm
REPLACE THE STORAGE DRAWER
A. Place the drawer rail on the guides. Push the drawer in until it stops. _1
B. Lift the front of the drawer and push in until the stops clear the
guides.
C. Lower the front of the drawer and push in until it closes.
COOKTOP BURNERS
ASSEMBLETHE BURNERS
_4, CAU TIO N:
The electrode of the spark igniter is exposed. Be careful not
to impact the electrode, as damage to the igniter could occur. Be careful not to turn on any
cooktop controls while touching an electrode. A slight electrical shock may occur.
If you have a glass ceramic cooktop, skip to l-_.
[] FOR METAL COOKTOPS
A. Place burner heads over the electrodes on the cooktop, in the correct locations according
to their sizes.
Medium head
and cap
I
®
Large head
and cap
O
ww w
Front of range
Small head
and cap
Large head
and cap
B. Make sure the slot in the burner head is positioned over the
electrode (on some models).
C. Place the matching size caps onto the heads.
Burner cap Burner cap
properly seated not properly
seated
8
Make sure that the heads and caps are placed in the correct locations.
Place the vent cover, grates and air inlet cover onto the cooktop, making sure that the grates
lock the vent cover in place.
Vent