To connect the TV
Connect your TV and this unit using the composite video
cord (supplied) or an S-video cord (not supplied).
• Using an S-video cord gives you a better quality pictures.
S-VIDEO
OUT
VIDEO
OUT
Composite video cord
(supplied)
To composite
video input
TV
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
• DO NOT plug in before setting the voltage
selector on the rear of the unit and all connection
procedures are complete.
VOLTAGE
SETTING
Using a screwdriver, set the voltage selector so that the arrow
printed on the rear points the correct voltage where you use
this unit. (See also the back cover page.)
S-video cord
(not supplied)
To S-video
input
MAIN SPEAKER
SUBWOOFER
[
4-8
]
[
6-16
]
L
L
R
R
LINE OUT
S-VIDEO
OUT
VIDEO
220
OUT
220
VOLTAGE
SETTING
NOW, you can plug in the unit and other
connected equipment FINALLY!
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
When the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
Cancelling the Display Demonstration
On the unit ONLY:
To cancel the display demonstration, press
DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing DEMO.
To start the display demonstration manually
Press and hold DEMO again for more than 2 seconds.
– 9 –
MAIN SPEAKER
SUBWOOFER
[
]
[
]
4-8
6-16
L
L
R
R
LINE OUT
S-VIDEO
OUT
VIDEO
220
OUT
VOLTAGE
SETTING
CANCEL
/DEMO