Recovering Data - Lenovo ThinkPad T400 Service And Troubleshooting Manual

Restoring the factory contents using the recovery discs
If a set of recovery discs is enclosed with your computer, or you have created
or purchased recovery discs, you can restore the factory contents by using the
discs in the following procedure:
1. Make sure that in the BIOS Setup Utility the startup sequence is set so that
2. Insert the Rescue and Recovery disc into the DVD drive.
3. Restart the computer. After a short wait, the Rescue and Recovery
4. Click Full Restore and follow the instructions on the screen.

Recovering data

If you performed a backup operation using the Rescue and Recovery
program, you also have one or more backups stored that reflect the contents
of the HDD or SSD as it existed at various points in time. These backups
might be stored on your HDD or SSD, or a network drive, or on removable
media, depending on the options you selected during the backup operation.
You can use either the Rescue and Recovery program or the Rescue and
Recovery workspace to restore the contents of the HDD or SSD to an earlier
state using any of the stored backups. The Rescue and Recovery workspace on
your HDD model runs independently of the Windows operating system.
Therefore, you can start it by pressing the blue ThinkVantage button when
prompted during startup.
After the Rescue and Recovery workspace opens you can perform a recovery
operation, even if you are unable to start Windows.
the system starts up from the recovery discs.
workspace opens.
Chapter 4. Recovery options
37