Recording; Recording On A Tape - JVC CA-FSH300 Instructions Manual

Recording

IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
• The recording level is automatically set correctly, so it is
not affected by the other sound settings. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can only use type I tape for recording.
• DO NOT turn off the unit while playing back or
recording a tape. The cassette deck or tapes
may be damaged.
• DO NOT use type II and type IV tapes since the
unit is not compatible with such tapes.
• The use of C-120 or longer tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.
At the start and end of cassette tapes
There is leader tape which cannot be recorded onto. Thus, when
recording from discs, FM/AM broadcasts, or external equipment,
wind the leader tape first to ensure that the recording will be made
without losing any music.
To protect your recordings
Cassettes have two small tabs on the back to protect against
unexpected erasure or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.

Recording on a Tape

On the unit ONLY:
1
Put a recordable cassette in with the exposed
part of the tape down.
• See also page 14.
2
Close the cassette holder gently.
17
3
4
5
• If no cassette is inserted when you press REC
• If a protected tape is inserted when you press REC
To stop recording for a moment, press REC.
The recording is paused. To resume recording,
press TAPE ¤ ‹.
To stop recording, press 7.
The recording stops.
To remove the cassette, press PUSH OPEN
while recording is stopped.
To record on both sides—Reverse Mode
Adhesive tape
On the remote control ONLY:
Press REV.MODE (reverse mode) until
• When using the Reverse Mode for recording,
To cancel the Reverse Mode, press REV.MODE repeatedly
until
To reduce the beat—Beat Cut
On the remote control ONLY:
If the beats are heard while recording an AM
broadcast, press BEAT CUT repeatedly until the
beats are reduced.
• Each time you press the button, the display
Start playing the source—FM, AM, or
auxiliary equipment connected to AUX jack.
• When the source is FM or AM, tune in to the station you
want to record.
• When recording from discs, see "Recording Discs—
Disc Synchronized Recording" on page 18.
Press REC (recording).
• The REC indicator appears and 3 indicator
lights up on the display.
Press TAPE ¤ ‹.
3 indicator starts flashing and the recording
starts.
"NO TAPE" appears on the display.
"PROTECT" appears on the display.
or is lit.
lights up and start recording in the forward
( 3 ) direction first.
is lit.
alternates between "CUT-1" and "CUT-2."
REC
REC
MHz
TAPE
REC
DOWN UP
4 7 ¢
PUSH OPEN
REV.MODE
BEAT CUT