Remote Ctrl - Sony ILCE-7S User Manual

Records the time code in Non-Drop Frame format.
*
The time code is based on 30 frames per second. However, a gap between the actual time and the time
code will occur during extended periods of recording as the frame frequency of the NTSC image signal is
approximately 29.97 frames per second. Drop frame corrects this gap to make the time code and actual
time equal. In drop frame, the first 2 frame numbers are removed every minute except for every tenth
minute. The time code without this correction is called non-drop frame.
The setting is fixed to [NDF] when recording in 1080/24p.
How to select the count up format for the time code (TC Run)
1. MENU→
the control wheel.
Rec Run:
Sets the stepping mode for the time code to advance only while recording. The time code is
recorded sequentially from the last time code of the previous recording.
Free Run:
Sets the stepping mode for the time code to advance anytime, regardless of the camera
operation.
The time code may not be recorded sequentially in the following situations even when the
time code advances in [Rec Run] mode.
When the recording format is changed.
When the recording medium is removed.
How to select how the time code is recorded (TC Make)
1. MENU→
the control wheel.
Preset:
Records the newly set time code on the recording medium.
Regenerate:
Reads the last time code for the previous recording from the recording medium and records
the new time code consecutively from the last time code. The time code advances in [Rec
Run] mode regardless of the [TC Run] setting.
[199] How to Use

Remote Ctrl

You can operate this product and shoot images using the SHUTTER button, 2SEC button (2
second delay shutter), and START/STOP button (or Movie button (RMT-DSLR2 only)) on the
(Setup) → [TC/UB Settings] → [TC Run], then press
(Setup) → [TC/UB Settings] → [TC Make], then press
Changing settings Setup menu
in the center of
in the center of