Makita GA4034 Technical Information page 11

W
iring diagram
Fig. D-5
Motor housing
(Back side view)
Motor housing
Brush holder
Rib
Noise suppressor
(if used)
Except AC/DC switch models
Motor housing
Noise
Suppressor
Motor housing
(Right side view)
Field lead wires (red, black) have
to be tight in Motor housing.
Pass Field lead wire (black) by
Rib on the Brush holder side.
Rib
edge of Rib B
1) Separate Lead wires (black, white)
of Power supply cord with Rib A.
2) Put the extra portions of Lead
wires (black, white) of Power
supply cord in this space so as not
to contact Rib B.
Field lead wires (red, black) have
to be tight in Motor housing.
Put the extra portions of Field lead wires
and Noise suppressor lead wires in this
area.
Face the wire side of Noise suppressor to
Motor housing, put Noise suppressor into
the space surrounded by Ribs and Boss.
Rib
Boss
Switch
Rib B
P 11/ 11
Motor housing
(Belly side view)
Rib A
Power supply
cord