Makita GA4034 Technical Information page 10

W
iring diagram
Fig. D-4
AC / DC Switch models (for Keppel corporation limited in Singapore, etc.)
Motor housing
Motor housing
Brush
holder
Field lead wires (red, black) have to be tight in Motor housing.
Put sag portion of Field lead wires in this area.
Connect Field lead wires
(red) to Switch, bending
them to inside at the
connecting portion to
Receptacle.
Motor housing
(Back side view)
Motor housing
(Right side view)
Field lead wires (red, black) have
to be tight in Motor housing.
Pass Field lead wire (black)
by Rib on Brush holder side.
Rib
Switch
Rib A
Edge of Rib B
1) Separate Lead wires (blue, brown)
of Power supply cord with Rib A.
2) Put the extra portions of Lead
wires ( blue, brown ) of Power
supply cord in this space so as
not to contact Rib B
Field Lead wire (red)
Receptacle
Switch
Motor housing
(Belly side view)
Power supply cord
Rib B
P 10/ 11