Installing Wireless Modules - Phonic performer A220 User Manual

INSTALLING WIRELESS MODULES (optional accessories)
Phonic wireless modules are very easy to install and allow your Performer active speaker to receive signals
from Phonic matched-frequency wireless UHF and VHF microphones, 2.4 GHz wireless mixer transmitter
modules and 2.4 GHz wireless transmitter modules installed in other Performer active speakers.
Follow these directions to install or uninstall a wireless module:
1. Locate the two wireless compartments on the top of the
Performer active speaker.
2. Using a Philips head screwdriver, remove one of the
compartment covers by removing the two screws that hold it
in place.
3. Insert the wireless module into the correct compartment. If you
are facing the back of the speaker, UHF and VHF wireless
modules should be installed in the compartment on the left,
and 2.4 GHZ wireless modules should be installed in the
compartment on the right. Make sure the wireless module is
right side up and that the card pins are lined up properly with
the pin receptors.
4. Replace the cover.
5. Replace the screws and tighten.
6. To uninstall wireless modules simply follow the above instructions, this time carefully removing the
wireless module from the compartment. Don't forget to replace the compartment cover when you are
finished.
Note: Phonic can only ensure that our wireless modules will work according to specifications, therefore only wireless
modules manufactured by Phonic should be used with Performer active speakers.
PHONIC CORPORATION Performer User's Manual
A: UHF/VHF Wireless Modules
B: 2.4 GHz Wireless Modules
page 15
B
A