Wireless Setup - Phonic performer A220 User Manual

Wireless Setup

4) System One:
This configuration uses a Phonic wireless microphone
with three Performer active speakers. You can use a
Phonic UHF or VHF wireless microphone with wireless
module to transmit to the speakers. Set the WIRELESS/
WIRELESS MIC Switch out (up) on the back of Speaker
, and set it in (down) on Speakers
1
is fitted with two wireless modules installed in the
1
two compartments on the top of the speaker. One
compartment has the matched-frequency wireless
module for the UHF or VHF wireless microphone. The
other compartment is fitted with a Wireless Transmitter
Module (WM 30) for re-transmitting the source signal
to other wireless-enabled Performer active speakers.
Speaker is fitted with a Wireless Transmitter/Receiver
2
Module (WM 50) for receiving the source signal
transmission from Speaker
Speaker , which is fitted with a Wireless Receiver
3
Module (WM 40). In this way you have a completely
wireless system with all the speakers receiving the same
signal from the wireless microphone. (To install wireless
modules please refer to the instructions on page 15.)
Note: The Wireless Transmitter modules (WM 30 and WM 50)
have a range of up to 100 feet (30 meters). If Speakers
are both within that range of distance from Speaker
only need to be fitted with a Wireless Receiver Module (WM 40).
Related Products: UM 11, UM 22, VM 11, VM 22, WM
30, WM 40, WM 50
PHONIC CORPORATION
and . Speaker
2 3
and re-transmitting it to
1
and
2
, then they
1
Performer User's Manual
SYSTEM ONE
up to 100 feet
(30 meters)
3
up to 100 feet
(30 meters)
2
up to 300 feet
(100 meters)
3
1
Performer Speaker
Performer Speaker
Performer Speaker
VHF / UHF Wireless
Microphone
2.4 GHz Transmitter (WM30)
2.4 GHz Receiver (WM400)
2.4 GHz Transmitter /
Receiver (WM50)
VHF / UHF Receiver
page 11