Adjusting The Audio Input Level; Changing The Scanning Mode; Changing The Picture Tone - JVC 0207WMKMDCJEM Instructions Manual

Adjusting the Audio Input Level

If the sound from the component connected to the
AUX jack is too loud or is too quiet when changing from
another source to "AUX," you can change the audio input
level through the AUX jack (without changing the volume
level).
While the "AUX" is selected as a source...
DVD/AUX
LEVEL AUX LVL1
AUX LVL1 Select this when the sound is too loud with
"AUX LVL2" selected. This setting is
recommended for listening and recording
when connecting an audio device other than a
portable audio device to the AUX jack.
AUX LVL2 Select this when the sound is too loud with
"AUX LVL3" selected.
AUX LVL3 Select this when listening to a portable audio
device or recording the sound from it (initial
setting).

Changing the Scanning Mode

Select the color system and the video signal mode according
to the type of your TV. If you connect a progressive TV to
the System through the COMPONENT jacks, you can enjoy
a high quality picture from the built-in DVD player by
selecting "PAL PRG" or "NTSC PRG."
SCAN MODE
9
(while holding...)
Select for a conventional PAL TV.
PAL
Select for a progressive PAL TV.
PAL PRG
Select to enjoy a progressive scanned
picture with a progressive PAL TV.
Select for a conventional NTSC TV.
NTSC
Select for a progressive NTSC TV.
NTSC PRG
Select to enjoy a progressive scanned
picture with a progressive NTSC TV.
14
Remote
ONLY
AUX LVL2
AUX LVL3
Remote
INFO
ONLY
PAL PAL PRG
NTSC PRG
NTSC
ENTER/SET

Changing the Picture Tone

• While showing a playback picture on the TV, you can
select a preset picture tone, or adjust it and store your own
taste.
To select a preset picture tone
1
While playing, display VFP setting screen.
VFP
10
(while holding...)
2 Select a preset picture tone.
Normally select this.
NORMAL
Suitable for a movie source.
CINEMA
You can adjust parameters and can
USER1/USER2
store the settings.
To remove the screen, press VFP again while holding
SHIFT.
To adjust the picture tone
1 Select "USER1" or "USER2."
• Follow steps 1 and 2 explained above.
2 Select a parameter you want to adjust.
TV CH
TV CH
Adjust if the neutral color is bright or
GAMMA
dark (–3 to +3).
Adjust if the entire picture is bright
BRIGHTNESS
or dark (–8 to +8).
Adjust if the far and near positions
CONTRAST
are unnatural (–7 to +7).
Adjust if the picture is whitish or
SATURATION
blackish (–7 to +7).
Adjust if the human skin color is
TINT
unnatural (–7 to +7).
Adjust if the picture is indistinct
SHARPNESS
(–8 to +8).
Remote
ONLY
NORMAL
GAMMA 0
0
BRIGHTNESS
0
CONTRAST
0
SATURATION
0
TINT
0
SHARPNESS
On the TV
NORMAL CINEMA
USER2 USER1
ENTER/SET