Changing The Display Brightness; Changing The Picture Tone; Adjusting The Audio Input Level - JVC UX-GD6M Instructions Manual

Changing the Display Brightness

You can dim the display window.
DIMMER
1
(at the same time)
DIM1
Dims the display.
DIM2
Erases the display illumination.
AUTO DIM
Erases the display illumination when
disc playback starts.*
• The display illuminates when
playback stops.
* "AUTO DIM" does not work for CD/MP3.

Changing the Picture Tone

• While showing a playback picture on the TV, you can
select the preset picture tone, or adjust it and store your
own taste.
To select a preset picture tone
1
While playing, display VFP setting screen.
VFP
4
(at the same time)
2
Select a preset picture tone.
NORMAL Normally select this.
CINEMA
Suitable for a movie source.
USER1/USER2
You can adjust parameters and can
store the settings.
To erase the screen, press VFP again while holding SHIFT.
14
Remote
ONLY
DIM2
DIM1
DIM OFF AUTO DIM
(Canceled)
Remote
ONLY
NORMAL
GAMMA 0
0
BRIGHTNESS
0
CONTRAST
0
SATURATION
0
TINT
0
SHARPNESS
On the TV
NORMAL CINEMA
USER2 USER1
To adjust the picture tone
1
Select "USER1" or "USER2."
• Follow steps 1 and 2 explained on the left column.
2
Select a parameter you want to adjust.
TV CH
TV CH
GAMMA Adjust if the neutral color is bright or
dark (–3 to +3).
BRIGHTNESS Adjust if the entire picture is bright or
dark (–8 to +8).
CONTRAST Adjust if the far and near positions
are unnatural (–7 to +7).
SATURATION Adjust if the picture is whitish or
blackish (–7 to +7).
TINT Adjust if the human skin color is
unnatural (–7 to +7).
SHARPNESS Adjust if the picture is indistinct
(–8 to +8).
3
Adjust the parameter.
TV CH
TV CH
4
Repeat steps 2 to 3 to adjust other parameters.
To erase the screen, press VFP again while holding SHIFT.

Adjusting the Audio Input Level

If the sound from the component connected to the
AUX jack is too loud or is not loud enough when changing
from another source to "AUX," you can change the audio
input level through the AUX jack (without changing the
volume level).
While the "AUX" is selected as a source...
2
sec.
CANCEL
SET
AUX LVL1 Select this when the sound is too loud (initial
setting).
AUX LVL2 Select this when the sound is not loud enough.
ENTER
ENTER
Remote
ONLY
AUX LVL1
AUX LVL2