Preparing The Remote Control - JVC 0207WMKMDCJEM Instructions Manual

TV/monitor
Connect the COMPONENT, S-VIDEO, or VIDEO jacks
which you want to use.
Green
Component video cord
(not supplied)
• To select progressive scanning mode (see page 14), use
COMPONENT jacks.
Composite video cord (supplied)
S-Video cord (not supplied)
• After connecting a TV, select the proper video signal mode
according to the connection method. See "Changing the
Scanning Mode" on page 14.
@
Digital audio component
Protective cap
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO" menu
correctly according to the connected digital audio
equipment (see page 36). If the setting is incorrect, loud
noise may be generated causing damage to the speakers.
When connecting a portable audio device (AUX)
Stereo mini plug
(not supplied)
• By using QP Link (Quick Portable Link), you can easily
start playing back a portable audio device on this unit. See
page 11 for details.
Red
Blue
At the front
panel
• If an external device is not equipped with a stereo mini plug
audio output, use a plug adaptor to convert the stereo mini
plug to the corresponding plug of the audio output.
When connecting a USB mass storage class device
USB cable
(not supplied)
• You can connect a USB mass storage class device such as a
USB flash memory device, hard disk drive, multimedia card
reader, etc. to this System. See pages 10 and 37 for details.
• If you press USB MEMORY 3, the System detects the
USB mass storage class device and the control screen
appears on the TV screen. See page 26 for details.
• You cannot connect a computer to the USB MEMORY
terminal of the System.
Before plugging in the System
(except for Australia)
Set the correct voltage for your area with the voltage selector
on the rear.
Use a screwdriver to set the voltage
VOLTAGE
selector to the same voltage as
SELECTOR
where you are plugging in the unit.
(See also the back cover page.)
110V
127V
220V
230V
-240V

Preparing the remote control

R6(SUM-3)/AA(15F)
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
DO NOT recharge, short, disassemble, heat
the battery or dispose of it in a fire.
When using the remote control
Point the top of the remote control toward the remote sensor
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
At the front
panel
5