Access Panels; Front Cowl Access; Access Panels Under Front Cowl; Access Panel On Floorboard - Cushman 898627 Parts & Maintenance Manual

SERVICE & MAINTENANCE Cont.

ACCESS PANELS

There are two access panels located under the front hood and one located in the middle of the floorboard.
Remove the screws securing the panel to the fire wall to gain access to the shifter linkage and some of the electrical
wiring for the instrument panel.
Remove the screws securing the panel to the bottom of the front cowl to gain access to the front suspension.
Access
Panels
Figure 39

Access Panels Under Front Cowl

Remove the screws securing the panel to the floorboard. This will give you access to the throttle cable, linkage, elec-
trical wire harness, as well as the brake lines which run to the master cylinder.
It will be necessary to remove the accelerator pedal in order to completely remove the center floorboard
panel.

FRONT COWL ACCESS

The front cowl opens to gain access to the fuse panel,
the horn, the master cylinder reservoir as well as vari-
ous access panels which when removed, allow
access to wiring for the dash panel, shifting lever link-
age and the upper part of the front suspension.
To open the front cowl, locate the release lever at the
upper left corner near the left side headlight.
Pull the lever to the right to release the front cowl latch
and at the same time pull up on the front cowl.
Open the cowl allowing it to rest against the rops struc-
ture (if equipped) or the steering wheel.
The front cowl will not "spring up" when the release
lever is pulled. The cowl will have to be raised when
the latch is released.
32
Access Panel
Removed
Release Lever
Access Panel In
Center Of Floorboard
Figure 40

Access Panel on Floorboard

Pull Lever
To Release
Cowl Latch
Front Cowl
Figure 41
Release Lever For Front Cowl