Epson TM-H6000IV Technical Reference Manual page 89

NV Graphics Print Mode
You can confirm the following information on the roll paper by running NV graphics print
mode:
• Capacity of the NV graphics
• Used amount of the NV graphics
• Unused capacity of the NV graphics
• Number of NV graphics that are registered
• Key code, number of dots in X direction, number of dots in Y direction
• NV graphics data
For detailed information about NV graphics, see
Starting the NV graphics print mode
Follow the steps below to run this mode.
1
Install the roll paper.
2
Close all covers and the receipt unit.
3
While pressing the Feed button, turn on the printer. (Keep pressing the
button until the printer starts printing.)
The printer starts printing the current status of the printer.
With the Ethernet interface, before printing starts, it takes 6 seconds if the IP address is
fixed and 13 seconds if the IP address is obtained with the automatic setting. (It may take
longer, depending on the response time from the host.)
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
4
Press the Feed button. (Keep pressing the button until the printer starts
printing.)
The printer starts printing instructions.
Chapter 3 Application Development Information
"Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection : 1 second or more"
"NV Graphics Memory" on page 22.
3
89