Contacting Customer Service; Limited Warranty - Bose Lifestyle DVD Operating Manual

REFERENCE
Problem What to do
A CD or DVD does not
•
Check the disc for scratches, fingerprints, smears, or dirt. See "Protecting and caring for
play correctly
your system" on page 55.
FM sound is distorted
•
Adjust antenna position to reduce interference.
FM sound is noisy
•
Weak FM stations will produce static in the surround speakers. Select the 2-speaker mode
in surround mode
in the Settings menu to minimize noise. See "Stored CDs settings options" on page 45.
Sound is distorted
•
Make sure speaker cables are not damaged and the connections are secure.
•
Reduce the output level from any external components connected to the media center.
No sound from
•
Check the connections.
TV, CD/DVD, VCR,
•
Make sure that component is turned on.
orAUX
•
Refer to the component owner's manual.
No video on screen,
•
Check the TV video input selection. Make sure it is correct for the video source.
though the TV audio
functions
L1FESTYLE® remote
•
Make sure correct codes are set. See "Using your L1FESTYLE® remote with other compo-
does not control
nents" on page 26.
your TV, VCR,
•
Make sure that the front of the media center is not obstructed. The IR emitter that sends
cable/satellite box,
commands to your external components is below the disc tray.
or other external
•
If you still cannot control your external components successfully, you may need to connect
component
the externallR emitter, included with your system, to the IR EMITTER jack on the rear
panel of the media center. See "IR emitter cable as an option" in your Installation Guide.
Your TV turns
•
Reposition the TV on/off sensor on the back of your TV. Or check the SCART connector if
on and off unexpectedly
you use one.
•
Verify that the TV on/off sensor is working properly by choosing TV Power Status under
Video in the System menu.
TV screen goes dark or
•
Use the media center to check the Video Format and Progressive Scan settings, following
image flips repeatedly
instructions in "Component system setup using the display" on page 13.
after making a change
- Video Format should be set to NTSC (U.S. standard) or PAL (European standard).
to a Video feature in
- Make sure the Progressive Scan setting is off, unless you have used a component video
System settings
connection and progressive scan is a feature of the TV.
You forgot
•
Enter the numbers 2673 as temporary password to access the parental controls. Then
your password
create a new password.
Contacting Customer SelVice
For additional help in solving problems, contact Bose® Customer Service. Refer to the
address sheet included in the carton.
Limited warranty
This system is covered by a transferable limited warranty.
Details of the limited warranty are provided on the Product Registration Card that came with
your system. Please fill out the information section on the card and mail it to Bose. However,
failure to do so will not affect your limited warranty rights.
58